Author: Mathias Lia Carlsen * This is a snippet from SPE-199982-MS that was presented on the SPE Canada Unconventional Resources Conference held virtually in 2020. The full manuscript can be found attached to this blog post. Decreasing CGRs are observed while flowing bottomhole pressures are above the (apparent) saturation pressure in several unconventional basins throughout […]
HOUSTON—17 December 2020—Stratum Reservoir and Whitson AS are pleased to announce a strategic partnership advancing the petroleum industry’s role in minimizing climate change and reducing carbon emissions. “This partnership further strengthens Stratum Reservoir’s position in this exciting market and enables the acceleration of carbon capture, utilization and storage [CCUS] adoption across the industry.” explained Stratum […]
Author: Ilina Yusra, Stian Mydland & Mathias Lia Carlsen After EOG Resources reported uplift results from their Eagle Ford Huff-n-Puff (HnP) activities, gas injection has gained significant traction in tight unconventionals. The success in the Eagle Ford has led companies to pursue gas HnP in other basins including Permian, SCOOP/STACK, Bakken and Montney. The HnP […]
Authors: Ahmad Alavian & Curtis Hays Whitson A contaminated sample is collected in an openhole formation testing tool (OFT) like MDT or RCI. The well has been drilled with oil based mud (OBM), where some percentage of the collected sample being OBM and the remainder being in-situ reservoir fluid. Finding a good estimate of the […]
Author: Arnaud Hoffmann To reduce CPU time in compositional petroleum simulation models (e.g. compositional reservoir simulations), a minimum number of components should be used in the equation of state (EOS) to describe the fluid phase and volumetric behavior. A ″detailed” EOS model often contains from 20 to 40 components, with the first 10 components representing […]
SPE-200396: Gas EOR Processes in Tight Unconventionals Q1) Why did you select the “minimum dimension” instead of “surface to volume ratio” to explain the dependence of the oil-recovery results on sample size. Hassan Dehghanpour (University of Alberta) We believe that the minimum dimension is easier to understand and relate to than the surface-to-volume ratio (S/V). […]
Author: Stian Mydland *This is a short-version of URTEC-2020-2765-MS presented at Unconventional Resources Technology Conference (URTeC) 2020. Paper can be downloaded in the end of this article. Reservoir simulation requires a fluid model to describe the volumetric behavior of gas and oil. When initiating a reservoir simulation study, we have to choose whether to use […]
Author: Mathias Lia Carlsen * This is a short-version of URTeC-2869-MS that was presented on the URTeC 21 July 2020. The manuscript can be found attached to this blog post. The HnP project studied in this paper involves a group of 11 wells configured such that four of the wells were subjected to cyclic injection […]
Author: Bilal Younus The term “single phase labeling” means to determine whether the given total composition zi (in a specific grid cell in the model) exists as single-phase “oil” or single-phase “gas” when the grid cell pressure is higher than the saturation pressure ps = f(zi,T), where T is the temperature in the model. A […]
Author: Mathias Carlsen Most reservoir engineering analysis in the petroleum industry is performed utilizing black oil tables. In general, there are three different types of black oil tables: (1) traditional, (2) modified and (3) extrapolated. These are visually presented in the figure above and becomes more “sophisticated” as we move from left to right. Traditional […]